Connecting A Hard Disk - Xante Accel a Writer 812 Manual

8. Double-click the Downloader icon to open that utility.
9. Choose Download PostScript File from the File menu.
10. Locate the Set Zone.ps file which you created in step 3.
11. Select the Set Zone.ps file and click Download. The following
status message appears when the downloading is complete.
The download was successful.
12. Click OK.
13. Select Quit from the File menu.
14. Turn the power to the printer off and on again.
If you need to connect a second host to another printer port, skip to
the section on connecting to the desired port in this chapter. If not
and you are connecting an optional hard disk, go to the next section
"Connecting a Hard Disk." Otherwise, skip to the next chapter,
"Macintosh Setup."

Connecting a Hard Disk

You can connect multiple hard disks to your printer via the SCSI
port. Adding a hard disk increases the available space for font
storage. You can download a font to RAM or to a hard disk.
However, a font stored in RAM has to be downloaded each time the
printer's power is turned off and on. If you store the font on a hard
disk, it remains there until you remove it.
Usually a 20 MB external hard disk is sufficient since this size can
hold approximately 500 to 600 extra fonts. However, if you use a
large number of fonts, you may want a larger disk or multiple disks.
To connect a hard disk to your printer, you need a SCSI peripheral
cable (25-pin to 50-pin). If the disk is not internally terminated, you
also need an external SCSI terminator. See the hard disk
documentation for termination characteristics.
__________________________________________ Installation 2-35