Printing The Start-Up Page - Xante Accel a Writer 812 Manual

Printing the Start-up Page

When you turn the printer on for the first time, it prints a start-up
page in approximately 90 seconds. The printer does not have to be
attached to a host to print this page.
The start-up page contains configuration information concerning
your printer. This information includes the printer name, emulation,
baud rate, RAM size, page count, resolution, flow control, hard disk
information (if applicable), and the current firmware version.
This page prints each time you start the printer unless you disable it.
Use the front panel or XANTÉ Command Center to disable this
feature.
Note: You can disable this page for an individual power cycle by
removing the paper cassette before turning the printer on and
replacing it after READY/IDLE appears in the display
window.
If you decide to disable this page, make sure to keep a copy for
reference on your printer setup. To disable this feature, see "Turning
the Start-up Page Off or On" either in chapter 3 for a Macintosh
environment or chapter 4 for a PC environment.
Note: To print an occasional start-up sheet without turning the
printer off, press the On Line key to take the printer off line.
Then press the Test
On Line key again to put the printer back on line.
__________________________________________ Installation 2-21
key. After the page prints, press the