Xante Accel a Writer 812 Manual page 216

f. Gently push the SIMM toward the left and up to a 90˚
angle (fig. 9.14) with the controller board until the two
bank latches snap in place in front. You may have to
hold the two latches out while pushing the SIMM into
place, and then release them. If you do not have another
SIMM to install, skip to step 10.
g. If you have another SIMM to install repeat steps a
through f.
11. Replace the EMI shield by placing the tabs on the bottom into
the slots on the printer and tilting it up into position (fig. 9.15).
____________________________________________
Fig. 9.15 Replace the EMI Shield
Options 9-19