Connecting A Hard Disk - Xante Accel-a-Writer 8200 Manual

11. Select the Set Zone.ps file and click Download. The following
status message appears when the downloading is complete.
The download was successful.
12. Click OK.
13. Select Quit from the File menu.
14. Turn the power to the printer off and on again.
If you need to connect a second host to another printer port, skip to
the section on connecting to the desired port in this chapter. If not
and you are connecting an optional hard disk, go to the next section
"Connecting a Hard Disk." Otherwise, skip to the next chapter,
"Macintosh Setup."

Connecting a Hard Disk

You can connect multiple hard disks to your printer via the SCSI
port. Adding a hard disk increases the available space for font
storage. You can download a font to RAM or to a hard disk.
However, a font stored in RAM has to be downloaded each time the
printer's power is turned off and on. If you store the font on a hard
disk, it remains there until you remove it.
Usually a 20 MB external hard disk is sufficient since this size can
hold approximately 500 to 600 extra fonts. However, if you use a
large number of fonts, you may want a larger disk or multiple disks.
To connect a hard disk to your printer, you will need a SCSI
peripheral cable (25-pin to 50-pin). If the disk is not internally
terminated, you also will need an external SCSI terminator. See the
hard disk documentation for termination characteristics.
Caution: You need to assign an identification number to your hard
disk. Do not turn on the printer or any attached hard disk
until the disk has been assigned a number. See your
SCSI disk documentation for details on assigning this
number.
__________________________________________ Installation 2-33