3.
Check the anti-static teeth area for paper dust and scrap residue
(fig. 6.11). If there is none, skip to the next section, "Installing
the New Cartridge."
4.
Clean off the dust and paper residue from the anti-static teeth
using the following procedure.
a.
Locate and remove the green cleaning brush inside the
right side of the printer (fig. 6.11)
b.
Locate the anti-static teeth and slide the cleaning brush
back and forth across them several times to remove
residue (fig. 6.11).
c.
Replace the brush in the right side of the printer (fig.
6.11).
Fig. 6.11 Clean the Anti-Static Teeth Area
Now that you have removed the old toner cartridge and cleaned the
anti-static teeth, you are ready to install a new cartridge using the
procedure in the next section.
6-26 Routine
Operationsbb
__________________________________