Removing Downloaded Fonts - Xante Accel a Writer 812 Manual

For information on installing a SCSI disk, see "Connecting a Hard
Disk" in chapter 2. That section also covers initializing a hard disk.
Note: Do not confuse the serial and SCSI interface ports when
connecting the cables. The printer has a 9-pin serial port, and
the printer ports are labeled clearly.
If you want to download fonts to the SCSI disk, see "Downloading to
a Hard Disk" in chapter 3 for a Macintosh environment or in chapter
4 for a PC environment. To remove downloaded fonts from the SCSI
disk, see the next section, "Removing Downloaded Fonts."

Removing Downloaded Fonts

To remove all downloaded fonts from printer memory, simply turn
the printer off and then back on. Fonts stored in printer memory only
last for the current power cycle. You can remove individual
downloaded fonts from memory with the Downloader in a Macintosh
environment, but not in a PC environment.
Removing downloaded fonts from a SCSI hard disk varies depending
upon the environment in which you work. This rest of this section
covers the Macintosh environment and then the PC environment.
In a Macintosh Environment, if you want to download fonts, the
Downloader included in your XANTÉ Utilities works best. See
"Loading Printer Fonts" in chapter 3 for details on downloading and
listing fonts on a SCSI disk.
To remove a font from the SCSI disk use the following procedure:
1. Make sure the SCSI disk is powered on and attached to the
printer's SCSI interface.
Note: Do not confuse the serial and SCSI interface ports
6-34 Routine Operationsbb
when connecting the cables. The printer has a 9-pin
serial port, and the printer ports are labeled clearly.
__________________________________