Configure The Desired Ip Address; Factory-Default Ip Settings; Sn4131 With 1 Ethernet Port: Connecting The Smartnode To The Lan; Factory Default Ip Address And Network Mask Configuration - Patton SmartNode 4131 User Manual

SmartNode 4131 User Manual
Figure 8. SN4131 with 1 Ethernet port: Connecting the SmartNode to the LAN
The SmartNode comes with a built-in DHCP client and a fixed IP address to simplify configuration. The
SmartNode will receive an IP address from the DHCP server in the network or it can be directly accessed using
the static IP address.

Configure the Desired IP Address

Factory-default IP Settings

The factory default configuration for the Ethernet interface IP addresses and network masks are listed in table 5.
Both Ethernet interfaces are activated upon power-up. LAN interface ETH 0/1 (LAN) provides a default
DHCP server, the WAN interface uses DHCP client to automatically assign the IP address and network mask.
Table 5. Factory Default IP Address and Network Mask Configuration
WAN Interface Ethernet 0 (ETH 0/0)
LAN Interface Ethernet 1 (ETH 0/1)
DHCP Address Range
If these addresses do not match with those of your network, go to the following section to change the addresses
and network masks.
IP routing is disabled on SN4131 models. See software license options to
Note
enable it.

Configure the Desired IP Address

IP Address
DHCP
192.168.1.1
192.168.1.10–192.168.1.99
4 • Initial Configuration
Network Mask
DHCP
255.255.255.0
255.255.255.0
30