Configure The Desired Ip Address; Factory-Default Ip Settings; Login - Patton SmartNode SN4170 User Manual

SmartNode 4170 User Manual
The SmartNode comes with a built-in DHCP client and a fixed IP address to simplify configuration. The
SmartNode will receive an IP address from the DHCP server in the network or it can be directly accessed using
the static IP address.

Configure the Desired IP Address

Factory-default IP Settings

The factory default configuration for the Ethernet interface IP addresses and network masks are listed in Table 5.
The Ethernet interface is activated upon power-up. The WAN interface uses DHCP client to automatically
assign the IP address and network mask.
Table 5. Factory Default IP Address and Network Mask Configuration
WAN Interface Ethernet 0 0(ETH 0/0)
Static IP Address
If these addresses match with those of your network, go to section
work" on page 30. Otherwise, refer to the following sections to change the addresses and network masks.

Login

To access the SmartNode, start the Telnet application. Type either the default IP address into the address field
of the Telnet application:
192.168.1.1
OR run the SmartNode Discovery Tool, to access the SmartNode.
Accessing your SmartNode via a Telnet session displays the login screen. Type the factory default login: admin
and leave the password empty. Press the Enter key after the password prompt.
Connecting the SmartNode 4171 to Your Laptop PC
Figure 8. Connecting the SmartNode to your Laptop PC
IP Address
DHCP DHCP
192.168.1.1 255.255.255.0
"Connecting the SmartNode to the Net-
4 • Initial Configuration
Network Mask
29