Installing An Interface Cable On The Smartnode Device's Fxs And Fxo Interface Ports; Rear View Showing Location Of Ethernet, Fxo, And Fxs Connectors, And Ground Lug (Smartnode 5550 Shown) - Patton SmartNode SN5550 User Manual
Enterprise session border controller, integrated access device, and voip gateway
Table of Contents
Advertisement
SmartNode 5550 & 4150 Series User Manual
3 • SmartNode Installation
Installing an interface cable on the SmartNode device's FXS and FXO interface ports
The SmartNode comes with at least two FXS analog ports (see
figure
9) located on the back of the device. Some
Models have FXO ports as well, with equal number of ports as for FXS. The FXS interfaces are connected to ana-
log devices via cables (see
figure 10
on page 37) terminated with RJ-11 connectors (see section
"Analog FXS"
on
page 61), while the same type of cable and pinout is being used to connect a POTS line to the FXO ports of the
SmartNode.
Figure 9. Rear view showing location of Ethernet, FXO, and FXS connectors, and ground lug
(SmartNode 5550 shown)
Installing the SmartNode device
35
Advertisement
Table of Contents
