Korg microARRANGER Owner's Manual page 226

224 Effects
Mono – Mono Chain

089: Rev-Gate
(Reverb – Gate)
This effect combines a mono‐type reverb and a gate.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
EQ Trim
+
Pre Delay
LEQ HEQ
Right
Input Reverb Mix
Gate+Dmpr
[R] Reverb Time [sec]
Sets the reverberation time
a
High Damp [%]
Sets the damping amount in the high range
[R] Pre Delay [msec]
b
Sets the delay time of the reverb sound and gate control signal
[R] EQ Trim
c
Table , "Sets the EQ input level," on page 176
[R] Pre LEQ Gain [dB]
Table , "Sets the gain of Low EQ," on page 176
d
Pre HEQ Gain [dB]
Table , "Sets the gain of High EQ," on page 176
[R] Reverb Balance
e
Sets the reverb effect balance
[G] Envelope Select
Switches between modulation source control and input signal control 
f
Src
Selects the modulation source that controls the gate when Envelope Select
is set to D-mod
Wet / Dry
Reverb
Reverb Gate
Reverb
Balance
Wet / Dry
Input
Envelope - Control
D-mod
Envelope Select
Gate
0.1...10.0sec
0...200msec
–15...+15dB
–15...+15dB
Dry, 1:99...99:1, Wet
D-mod, Input
Off...Gate2+Dmpr
[G] Input Reverb Mix
Sets the balance between the dry and reverb sounds of the gate control sig-
nal.
g
Threshold
Sets the gate threshold level
[G] Polarity
h Switches between non-invert and invert of the gate on/off state
[G] Attack
Sets the attack time
i
Release
Sets the release time
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
j
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
0...100%
f: Envelope Select, f: Src, g: Input Reverb Mix, g: Threshold
The "Envelope Select" parameter enables you to select
whether turning the gate on and off is triggered by the input
signal level or controlled directly by the modulation source.
0...100
You can select from Off to Gate2+Dmpr for the Src parameter
to specify the modulation source.
When "Envelope Select" is set to Input, the gate is controlled
by the level of signals that are the combination of the dry
sound and the reverb sound. When the signal level exceeds
the threshold, the gate opens and the reverb sound is output.
Normally, set "Input Reverb Mix" to Dry (the gate is controlled
only by the dry sound). If you wish to extend the gate time, set

the "Input Reverb Mix" value higher and adjust the "Thresh-
old" value.

Dry, 1:99...99:1, Wet

0...100

+, –
Fx:005
1...100
Fx:005
1...100
Fx:005
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100