198
Effects
Mod./P.Shift
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
h
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
a: Pre LPF
This parameter enables you to set the damping amount of the
high range sound input to the ring modulator. If the input
sound contains lots of harmonics, the effect may sound dirty.
In this case, cut a certain amount of high range.
b: OSC Mode
This parameter determines whether or not the oscillator fre-
quency follows the note number.
c: Fixed Frequency [Hz]
This parameter sets the oscillator frequency when "OSC
Mode" is set to Fixed.
d: Note Offset, d: Note Fine
These parameters for the oscillator are used when "OSC
Mode" is set to Note (Key Follow). The "Note Offset" sets the
pitch difference from the original note in semitone steps. The
"Note Fine" parameter fine-adjusts the pitch in cent steps.
Matching the oscillator frequency with the note number pro-
duces a ring modulation effect in the correct key.
037: Detune
Dry, 1:99...99:1, Wet
Using this effect, you can obtain a detune effect that
offsets the pitch of the effect sound slightly from the
Off...Tempo
pitch of the input signal. Compared to the chorus
–100...+100
effect, a more natural sound thickness will be created.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Right
Pitch Shift [cent]
Sets the pitch difference from the input signal
Src
a
Selects the modulation source of the pitch shift
Amt
Sets the modulation amount of the pitch shift
Delay Time [msec]
b
Sets the delay time
Feedback
Sets the feedback amount
c
High Damp [%]
Sets the damping amount in the high range
Input Level Dmod [%]
Sets the modulation amount of the input level
d
Src
Selects the modulation source for the input level
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
e
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
d: Input Level Dmod [%], d: Src
This parameter sets the dynamic modulation of the input
level.
Input Level
High Damp
+
Detune
Delay
Input Level
Input Level
Input Level
x1.0
Amt= +50
x1.0
Amt= +100
x0.5
x0.5
D
-mod
Higher
Zero
Max
Zero
Wet / Dry
Feedback
Wet / Dry
–100...+100cent
Off...Tempo
–100...+100cent
0...1000msec
–100...+100
0...100%
–100...+100
,
Off...Tempo
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
Input Level D-mod
Amt= –50
Amt= –100
D
-mod
Higher
Max