Korg microARRANGER Owner's Manual page 20

Professional arranger
Hide thumbs Also See for microARRANGER:
Table of Contents

Advertisement

18
Front panel
Note:  The  Master  Transpose  has  no  effect  on  tracks  set  to 
Drum  mode  (and,  even  if  set  in  a  different  status,  on  the 
Drum and Percussion tracks). See "Page 14 ‐ Track: Mode" 
on page 46, and "Page 7 ‐ Track: Mode" on page 78.
Lowers the Master Transpose a semitone.
Raises the Master Transpose a semitone.
47 OCTAVE
These buttons transpose the selected track in steps of a 
whole octave (12 semitones; max ±2 octaves). The trans‐
position  value  is  shown  (in  octaves)  on  the  top  right 
area of the display.
Press both buttons together, to reset the Octave Trans‐
pose to zero.
Note:  The  Octave  Transpose  has  no  effect  on  tracks  set  to 
Drum  mode  (and,  even  if  set  in  a  different  status,  on  the 
Drum and Percussion tracks).
Lowers the selected track an octave.
+
Raises the selected track an octave.
48 BALANCE slider
In Song Play mode, this slider balances the volume of 
the  two  on‐board  sequencers.  When  fully  on  the  left, 
only Sequencer 1 can be heard. When fully on the right, 
only  Sequencer  2  can  be  heard.  When  in  the  middle, 
both sequencers will play at full volume.
49 SEQUENCER TRANSPORT CONTROLS - SEQ1
and SEQ2
The  instrument  is  equipped  with  two  sequencers 
(Sequencer 1 and Sequencer 2), each with its own set of 
transport controls.
<< and >>
Rewind  and  Fast  Forward  commands.  If 
you  use  them  while  the  Song  is  in  play, 
they make it scroll back or forward.
When  pressed  once,  these  buttons  move 
the  Song  to  the  previous  or  following 
measure.  When  kept  pressed,  they  make 
the  Song  scroll  continuously,  until  you 
release them.
 In  Jukebox  mode  (Sequencer  1), 
keep the SHIFT button pressed, and press 
these  buttons  to  scroll  to  the  previous  or 
next Song in the Jukebox list (see "Page 9 ‐ 
Jukebox" on page 79).
PAUSE
Pauses  the  Song  at  the  current  position. 
Press  PAUSE  or  PLAY/STOP  to  start  the 
Song playing again.
PLAY/STOP Starts  or  stops  the  current  Song.  When 
you stop the Song, the Song Position goes 
back to measure 1.
 In  Song  Play  mode,  pressing  this 
button  while  keeping  SHIFT  pressed, 
starts both sequencers at the same time.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents