106
Program operating mode
Edit page structure
EDIT PAGE STRUCTURE
Select an edit section from the Menu, and/or use the
PAGE buttons to reach the desired page.
Press EXIT to go back to the main page of the Program
mode.
All edit pages share the same structure.
Program icon Page header
Parameters
Program icon
When switched on, this icon shows that the instrument
is in Program mode.
Page header
The header shows the name of the current edit page.
Oscillator in edit
When in an edit page where selecting an oscillator is
required, this area shows the selected oscillator. Use the F‐
1–F‐4 buttons to select one of the four available oscillators.
Page number
This area shows the current page number.
Parameters
Select an edit parameter using the A–D VOLUME/
VALUE buttons. You can scroll the parameter list using
the E–F (Scroll Up) and G–H (Scroll Down) VOLUME/
VALUE buttons.
Parameter value
Use the A–D VOLUME/VALUE buttons, or the
TEMPO/VALUE controls, to change the parameter
value.
THE COMPARE FUNCTION
While in edit, you can compare the current Program
with its original values. You cannot edit the Program
while you are in Compare mode.
•
Keep the SHIFT button pressed, and press ENTER
to enter the Compare function. The PROGRAM
LED begins flashing. Play on the keyboard to lis‐
ten to the original Program.
•
Press SHITF + ENTER again to exit the Compare
mode and return to the edited Program.
HOW TO SELECT OSCILLATORS
While in an edit page requiring an oscillator to be
selected for editing, use the F‐1–F‐4 buttons to select
one of the available oscillators.
Page number
Oscillator in edit
Parameters value
ERASE PROGRAM/OSCILLATOR
You can initialize any parameter value, by using one
of the following shortcuts:
•
While in the Basic page, keep the SHIFT button
pressed, and press the DELETE button to initialize
the whole Program to a default status.
•
While in an edit page where the "Osc" abbrevia‐
tion appears in the upper right area of the display,
keep the SHIFT button pressed, and press the
DELETE button to initialize the currently selected
oscillator to a default status
After you press the shortcut, the "Init osc?" message
appears. Press ENTER to confirm, EXIT to abort.
THE 'WRITE' WINDOW
This page appears when you press the WRITE button.
Here you can save the Program into a User Program
location in memory.
1. Select a name and a location, then press ENTER to
save the Program.
2.
The "Are you sure?" message appears. Press
ENTER to confirm, or EXIT to abort.
Warning: If you write over an existing User Program,
the Program will be deleted and replaced by the one you
are saving ("overwrite"). Please save to card any Pro‐
gram you don't want to lose.
Name
Use this parameter to change the Program's name.
Press the right A VOLUME/VALUE button to enter
editing. Modify the name using the UP/DOWN buttons
to move the cursor, and the DIAL to select a character.
Press INSERT to insert a character at the cursor posi‐
tion, or DELETE to delete it
To (Location number)
Use the B VOLUME/VALUE buttons to select a differ‐
ent User Program location in memory. Otherwise,
select this parameter and use the VOLUME/VALUE
controls to select the location.
Note: You can't save over a Factory Program location.