Korg microARRANGER Owner's Manual page 184

182 Effects
Filter/Dynamic
When "LFO Waveform" is set to Random, the "LFO Step
Freq" parameter uses a random LFO cycle.
LFO Frequency
LFO Step Freq
Step-Tri
b: LFO Phase [degree]
Offsetting the left and right phases alters how modulation is
applied to the left and right channels, creating a swelling
affect.
–180 –90
e: BPM, f: Step Base Note, f: Times
The width of an LFO step, or a cycle of random LFO, is
obtained by multiplying the length of a note ( ... ) (selected
for "Step Base Note", in relation to the tempo specified in
"BPM," or the MIDI Clock tempo if "BPM" is set to MIDI) by
the number specified in the "Times" parameter.
j: Wet/Dry
The effect sound's phase will be reversed when you set this
parameter in the range of values from –Wet to –1:99.
Random Filter LFO
LFO Step Freq
Random
LFO Phase
0 +90 +180 [degree]
0 [degree]

011: Excit/Enhan
(Stereo Exciter/Enhancer)
This effect is a combination of the Exciter, which adds a
punch to the sound and the Enhancer, which adds
spread and presence.
Stereo In - Stereo Out
Left
LEQ HEQ
Exciter
EQ Trim
EQ Trim
Exciter
Right
D
-mod
Exciter Blend
Sets the intensity (depth) of the Exciter effect
Src
a
Selects the modulation source of the Exciter intensity
Amt
Sets the modulation amount of the Exciter intensity
Emphatic Point
Sets the frequency to be emphasized
Src
b
Selects the modulation source of the frequency to be emphasized
Amt
Sets the amount of modulation of the frequency to be emphasized
Enhancer Dly L (Enhancer Delay L) [msec]
c
Sets the delay time for the Enhancer left channel
Enhancer Dly R (Enhancer Delay R) [msec]
d
Sets the delay time for the Enhancer right channel
Enhancer Depth
Sets the determines to what degree the Enhancer effect is applied
e Src
Selects the modulation source of the Enhancer width
Amt
Sets the modulation amount of the Enhancer width
EQ Trim
f
Sets the 2-band EQ input level
Pre LEQ Gain [dB]
Table , "Sets the gain of Low EQ," on page 176
g
Pre HEQ Gain [dB]
Table , "Sets the gain of High EQ," on page 176
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
h
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
a: Exciter Blend
This parameter sets the depth (intensity) of the Exciter effect.
Positive values give a frequency pattern (to be emphasized)
different from negative values.
b: Emphatic Point
This parameter sets the frequency to be emphasized. Higher
values will emphasize lower frequencies.
c: Enhancer Dly L [msec], d: Enhancer Dly R [msec]
These parameters set the delay time for the Enhancer left
and right channel. Specifying a slightly different delay time for
the left and right channel will add a stereo image, depth, and
width to the sound.
Wet / Dry
Delay
Depth
Delay
Enhancer
Wet / Dry
–100...+100
,
Off...Tempo
–100...+100
0...70
,
Off...Tempo
–70...+70
0.0...50.0msec

0.0...50.0msec

0...100
Off...Tempo
–100...+100
0...100
–15.0...+15.0dB
–15.0...+15.0dB
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100