18. EFFECTS
microARRANGER is equipped with four powerful
Effect Processors (A, B, C, D). You can send them the
internal tracks.
DIAGRAMS
The following instructions show the signal path dia‐
gram for each of the effect types. The signal coming
from the tracks (Send) is mono. Before entering an
effect processor, it is split in two "wires" (Left and
Right), and processed in stereo. The signal is then out‐
put in stereo from the effect processor, and sent to the
Mix output (Left&Right, the heaphones or the internal
speakers).
Effect Block
Diagram
Send
DYNAMIC MODULATION SOURCES
When the
symbol is encoutered, a Dynamic Mod‐
ulation can be applied to the corresponding parameter.
The following table shows the available modulation
sources.
Modulation source
Note
Off
No modulation
Gate1
Gate1+Dmpr
Gate2
Gate2+Dmpr
Note Nr
Note Number
Velocity
Note Velocity
ATouch
After Touch
JS X
Joystick Left/Right
JS+Y: CC#01
Joystick Forward
JS-Y: CC#02
Joystick Backward
MIDI(CC#04)
MIDI(CC#12)
MIDI(CC#13)
MIDI(CC#16)
MIDI(CC#18)
MIDI(CC#17)
Modulation source
MIDI(CC#19)
MIDI(CC#20)
MIDI(CC#21)
Damper: #64
Prta.SW: #65
Sostenu: #66
MIDI(CC#80)
MIDI(CC#81)
MIDI(CC#82)
MIDI(CC#83)
Left
Tempo
Right
FILTER/DYNAMIC
Filter and dynamics control effects
000: No Effect
Select this option when you do not use any effects.
When this option is selected, the effect is muted.
001: Amp Simulat
(Stereo Amp Simulation)
This effect simulates the frequency response character‐
istics of guitar amplifiers. It is also effective for organ
and drum sounds.
Stereo In - Stereo Out
Left
Right
Amplifier Type
a
Selects the type of guitar amplifier
Wet/Dry
Sets the balance between the effect and dry sounds
Src
b
Selects the modulation source of the effect balance
Amt
Sets the modulation amount of the effect balance
Effects
Diagrams
Note
Portamento Switch
Sostenuto Pedal
Wet / Dry
Amp Simulation Filter
Amp Simulation Filter
Wet / Dry
SS, EL84, 6L6
Dry, 1:99...99:1, Wet
175
Off...Tempo
–100...+100