Stereo Gate - Korg microARRANGER Owner's Manual

178 Effects
Filter/Dynamic

005: Gate

(Stereo Gate)

This effect mutes the input signal if its level is lower
than the specified level. It also reverses the on and off
operation of the gate, and uses Note On and Off mes‐
sages to turn the gate on and off.
Stereo In - Stereo Out
Left
Envelope - Control
+
Envelope - Control
Envelope Select
Right
Gate+Sus
Envelope Select
Selects from Control via the modulation source, mixing the left and right sig-
nals, Only left, and Only right
a
Src
Selects the modulation source that controls the gate when Envelope Select =
D-mod
Polarity
b
Switches between non-reversed and reversed Gate on/off
Threshold
c
Sets the level to which the Gate is applied
Attack
Sets the attack time
d
Release
Sets the release time
Delay Time [msec]
e
Sets the delay time of the gate input
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
f
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
a: Envelope Select, a: Src
The "Envelope Select" parameter selects whether the gate
on/off is triggered by the level of the input signal, or controlled
directly by the modulation source. The Src parameter speci-
fies the modulation
Gate2+Dpmr.
With "Envelope Select" = L/R Mix, the left and right channel
signal mixture will trigger the gate on/off. When L Only or R
Only is selected, the gate is controlled by either of the chan-
nel signals.
b: Polarity
This parameter reverses the Gate on/off operation. With a
negative value, the gate is closed when the input signal level
exceeds the Threshold. The gate operation controlled by the
modulation source is also reversed.
c: Threshold, d: Attack, d: Release
This parameter sets the signal level below which Gate is
applied when "Envelope Select" is set to L/R Mix, L Only, or
R Only.
Wet / Dry
Delay Gate
Delay Gate
Wet / Dry
D-mod, L/R Mix, L Only, R Only
,
Off...Gate2+Dmpr
0...100msec
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
source, selected from Off
The Attack and Release parameters set the Gate attack time
and release time.
Output Level
Dry
Wet
Wet
e: Delay Time
This parameter sets the delay time of the Gate input. If the
+, –

sound has a very fast attack, increase the delay time so that
the signal will be input after the Gate is opened. This will pre-
0...100

serve the attack part of the sound.
1...100

006: OD/HGainWah
1...100

(Overdrive/Hi.Gain Wah)
This distortion effect utilizes an Overdrive mode and a

Hi‐Gain mode. Controlling the wah effect, the 3‐band
EQ, and the amp simulation will allow you to create
versatile distortion sounds. This effect is suitable for
guitar and organ sounds.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Pre Low-cut
+
Right
to
D
-mod
Wah
Switches Wah on/off
Src
a Selects the modulation source that switches the Wah on and off
Sw
Selects the switching mode for the modulation source that switches the Wah
on and off
Wah Sweep Range
Sets the range of Wah
b
Wah Sweep Src
Selects the modulation source that controls the Wah
Drive Mode
c
Switches between overdrive and hi-gain distortion
Drive
Sets the degree of distortion
d
Pre Low-cut
Sets the low range cut amount of the distortion input
Output Level
Sets the output level
Src
e
Selects the modulation source for the output level
Amt
Sets the modulation amount of the output level
Gate - Threshold
Threshold
Louder
Input Level
Gate - Attack / Release
Threshold
Attack=1
Release=1
Attack=100
Release=100
Release
Attack

Mode: Overdrive / Hi-Gain
Drive
3 Band PEQ
Driver Amp Simulation
Wah
Output Level
Direct Mix
Wet / Dry
Wet / Dry
Off, On
,
Off...Tempo
Toggle, Moment

–10...+10
,
Off...Tempo

Overdrive, Hi-Gain
1...100

0...10

0...50
,
Off...Tempo
–50...+50