Performing Modification Of Needle Entry Point; ChangNg The Thread TensOn Value - JUKI AMS-224E/IP-410 Instruction Manual

2-8. Performing modification of needle entry point
A
C
D
F
J
Thread tenson value and ntermedate presser heght of the needle
entry pont can be changed.
(1) changing the thread tension value
Press THREAD TENSION button
screen to dsplay the thread tenson settng screen.
Press THREAD TENSION SELECTION button
dsplay the thread tenson command selecton screen.
B
When C s pressed, the thread tenson value ncrease/
decrease nput screen s dsplayed.
Wth D or
or rear n the state that the presser s lowered.
Wth F or
entry pont where there s the thread tenson command n the
E
front or rear.
I
When you desre to stop, press STOP button
H
Press ORIGIN MOVE button
G
to the start of sewng poston.
The value whch s dsplayed s the absolute value (thread
tenson value + thread tenson command value).
Input the value you desre wth TEN keys and +/– keys J .
When ENTER button
mned.
When checking the needle, or performing the feed for-
ward or backward, the machine fails to work unless the
presser is lowered. use the machine after lowering the
K
presser.
– 30 –
A n the sewng
E , needle moves by one sttch n front
G the needle moves to the needle
I and the needle moves
K s pressed, the data s deter-
B to
H .