Chapter 2 Setup
>
2.2 Modifying the ETERNUSmgr Setup
Device Specific Setup Parameters (differences only)
Setting item
Target Device
(may be
changed)
Target Flag
(cannot be
changed)
2.2
Modifying the ETERNUSmgr Setup
This section explains how to change the setup of ETERNUSmgr for Solaris OS, HP-UX, AIX,
Linux, or Windows®.
Use a text editor to modify the setup file. Any text editor can be used as none has been specified.
2.2.1
ETERNUSmgr for Solaris OS, HP-UX, AIX, and Linux Procedure
This section explains what to do for the Solaris OS, HP-UX, AIX, and Linux versions of
ETERNUSmgr.
The procedure shown is for changing the settings that were set during installation.
This explanation uses ETERNUSmgr's default installation directory "/opt/FJSVgrmgr/" as an
example.
Procedure
1
P2X0-0202-04ENZ0
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
Parameter
TARGET_TYPE
TARGET_FLAG
Confirm the contents of the installation directory.
Make sure that the necessary files and directories (stxchk, _STXPOLL.INI,
STXPOLL_1.INI, stxpoll, stxpolld, www/) have all been installed.
# ls /opt/FVSVgrmgr/
stxchk _STXPOLL.INI
Target Type
ETERNUS
ETERNUS
GR710, GR720,
GR740, GR820,
GR730,
GR840,
ETERNUS3000
ETERNUS6000
Default setting is
Default setting is
"GR710",
"GR740",
"GR720",
"GR820",
"GR730", or
"GR840", or
"ETERNUS3000"
"ETERNUS6000"
Fixed at "1"
Fixed at "2"
STXPOLL_1.INI
stxpoll
17
ETERNUS DX400
series,
ETERNUS DX8000
series,
ETERNUS2000,
ETERNUS4000,
ETERNUS8000
Default setting is
"ETERNUS DX400",
"ETERNUS DX8000",
"ETERNUS2000",
"ETERNUS4000", or
"ETERNUS8000"
Fixed at "4"
stxpolld
www/
Copyright 2009 FUJITSU LIMITED