Configuring For Snmp Management - Polycom QDX 6000 System Administrator's Manual

To download the Polycom MIBs:
1. On a computer, open a web browser.
2. In the browser address line, enter the IP address of the system, for
example,
http://10.11.12.13
interface.
3. Go to Admin Settings > Global Services > SNMP.
4. Click Download MIB and follow the onscreen instructions.

Configuring for SNMP Management

To configure the Polycom QDX 6000 system for SNMP Management:
1. Access the SNMP configuration screen either in the Polycom QDX 6000
web interface or on the Polycom QDX 6000 system.
— In the Polycom QDX 6000 web interface go to Admin Settings >
Global Services > SNMP.
— On the Polycom QDX 6000 system go to System > Admin Settings >
Global Services > SNMP.
2. Configure these settings on the SNMP screen:
Setting
Enable SNMP
Trap Version
Read-Only
Community
Contact Name
Location Name
System Description
Console IP
Address
, to go to the Polycom QDX 6000 web
Description
Allows administrators to manage the system remotely
using SNMP.
Specifies the trap protocol that the system uses.
• v2c—System uses the v2c trap.
• v1—System uses the v1 trap.
Specifies the SNMP management community in which you
want to enable this system. The default community is
public.
Note: Polycom does not support SNMP write operations
for configuration and provisioning; the read-only
community string is used for both read operations and
outgoing SNMP traps.
Specifies the name of the person responsible for remote
management of this system.
Specifies the location of the system.
Specifies the type of video conferencing device.
Specifies the IP address of the computer you intend to use
as your network management station and to which SNMP
traps will be sent.
Managing the System Remotely
9 - 5