Polycom QDX 6000 System Administrator's Manual page 79

Security Mode requires secure access and a password for Web access.
When you enable Security Mode, the following settings are set and controlled
by the system:
Setting
AES Encryption
Enable Remote
Access: Telnet
Enable Remote
Access: SNMP
Web Access Port
Allow Video Display
on Web
Auto Answer
Settings
User Settings
Minimum Password
Length
To configure the system to use Security Mode:
1. Go to System > Admin Settings > General Settings > Security >
Security Settings.
2. Enable Security Mode.
When you change this setting, the Polycom QDX 6000 system restarts. Every
time a Polycom QDX 6000 system is powered on or restarts in Security Mode,
it verifies that the system software is authentic Polycom software.
Restriction
Set to Required for Video Calls Only (or When
Available after an upgrade), configurable
Disabled for port 23 and 24, read-only
Disabled, read-only
Port 80 disabled with no redirect to port 443, read-only
Port 443: Available for HTTPS, read-only
Disabled, configurable
Auto Answer Point-to-Point: Disabled, configurable
Mute Auto-Answer Calls: Hidden
Allow Video Display on Web: Hidden
Far Control of Near Camera: Hidden
Set to 1, must be at least 1
Security
8 - 5