Stereosurround Settings - Polycom QDX 6000 System Administrator's Manual

StereoSurround Settings

4. Select and enter these settings on the VCR/DVD screen:
Setting
Line In Level
Line Out Level
Auxiliary Audio
Input Association
VCR/DVD Audio
Out Always On
Line In Level
(dB meter)
Line Out Level
(dB meter)
5. Select and enter these settings on the Audio Levels screen:
Setting
Master Audio
Volume
To send or receive stereo audio, make sure your Polycom QDX 6000 system
equipment is set up as described in
6000 Microphone Input
4-2. Then configure the system to use Polycom StereoSurround, test the system
configuration, and place a test call.
Description
Sets the volume level for VCR or DVD input.
Sets the volume level for VCR or DVD output.
Sets whether to associate current video source. If it is set
to associate current video source, you can hear the
VCR/DVD player audio through Line Output audio.
If you want to play the VCR/DVD player audio through Line
Output audio, do one of the following,
• If current video source is the main camera, set this
setting to Main Camera.
• If current video source is AUX / DOC / VCR / VGA, set
to corresponding video source.
Allows you to record a call using one VCR or DVD, while
playing content into the call from a second VCR or DVD.
Do not select this setting if you have only one VCR or DVD
player connected. If this setting is disabled, the VCR audio
output is disabled when VCR is the selected camera
source.
Lets you see the peak input signal level present at VCR or
DVD audio input.
Lets you see the peak output signal level present at VCR
or DVD audio output.
Description
Sets the volume level for audio from the far site.
Connecting Devices to the Polycom QDX
on page 4-1 and Connecting Audio Output
Microphones and Speakers
on page
4 - 5