Polycom QDX 6000 System Administrator's Manual page 16

Administrator Guide for Polycom QDX 6000 System
2 - 4
Setting Description
LAN Speed Specify the LAN speed to use. Note that the speed you choose
must be supported by the switch.
Choose Auto to have the network switch negotiate the speed
automatically. Choosing Auto automatically sets Duplex Mode to
Auto. If you choose 10 Mbps, or 100 Mbps you must set Duplex
Mode to Half or Full.
Note: Polycom does not support Auto for the Polycom QDX 6000
system only or the switch only; the settings for both must be the
same.
Changing this setting causes the system to restart.
Duplex Mode Specify the duplex mode to use. Note that the Duplex mode you
choose must be supported by the switch.
Choose Auto to have the network switch negotiate the Duplex
mode automatically. Choosing Auto automatically sets LAN
Speed to Auto.
Note: Polycom does not support Auto for the Polycom QDX 6000
system only or the switch only; the settings for both must be the
same.
Changing this setting causes the system to restart.
4. Select and configure these settings:
Setting Description
Enable Specifies whether EAP/802.1X network access is enabled.
EAP/802.1X Polycom QDX 6000 systems support the following
authentication protocols:
•
•
•
Identity Specifies the system's identity used for 802.1X authentication.
This setting is available only when EAP/802.1X is enabled.
Password Specifies the system's password used for 802.1X
authentication. This setting is available only when EAP/802.1X
is enabled.
Enable 802.1p/Q Specifies whether VLAN and link layer priorities are enabled.
VLAN ID Specifies the identification of the Virtual LAN.This setting is
available only when 802.1p/Q is enabled. The value can be
any number from 1 to 4094.
Video Priority Sets the link layer priority of video traffic on the LAN. Video
traffic is any RTP traffic consisting of video data and any
associated RTCP traffic. This setting is available only when
802.1p/Q is enabled. The value can be any number from 0 to
7, although 6 and 7 are not recommended.
EAP-MD5
EAP-PEAPv0 (MSCHAPv2)
EAP-TTLS