Polycom Microphone Lights; Connecting Audio Output; Connecting Speakers To Polycom Qdx 6000 Systems - Polycom QDX 6000 System Administrator's Manual

Administrator Guide for Polycom QDX 6000 System

Polycom Microphone Lights

Connecting Audio Output

Connecting Speakers to Polycom QDX 6000 Systems

Audio Output Number
Line Out (Main Audio)
VCR OUT (VCR/DVD
Player)
4 - 2
For best audio:
• Place the microphone on a hard, flat surface (table, wall, or ceiling) away
from obstructions, so the sound will be directed into the microphone
elements properly.
• Place the microphone near the people closest to the monitor.
• In large conference rooms, you may need more than one microphone.
Each Polycom microphone covers a 3-6 foot radius, depending on the
noise level and acoustics in the room.
The following table describes the behavior of the microphone lights.
Microphone Light
Off
Green
Red
You must connect at least one speaker to Polycom QDX 6000 systems in order
to hear audio. You can use the speakers built into the main monitor, or you can
connect an external speaker system such as the Polycom StereoSurround kit to
provide more volume and richer sound in large rooms.
Refer to your system's setup sheet for connection details. Make sure that the
system is powered off before you connect devices to it.
The following table describes the audio outputs of the Polycom QDX 6000
system.
Connector Output Type
RCA Mono/Stereo
RCA Mono/Stereo
Status
Not in a call
In a call, mute off
Mute on
Audio Mix Routed to the Output
System tones and sound effects +
Audio from the far site
Near-site talkers +
Audio from the far site