Adjusting The Monitor's Color Balance, Sharpness, And Brightness - Polycom QDX 6000 System Administrator's Manual

Adjusting the Monitor's Color Balance, Sharpness, and Brightness

To specify whether and when to display the PIP:
1. Select System from the Place a Call screen.
2. Select User Settings from the System screen.
3. Select to see more settings
4. Scroll to PIP, and select one of these settings:
Select this setting...
On
Auto
Off
To show the PIP during a call:
 Repeatedly pressing
display. PIP can change to show the near or far site.
In most cases, the monitor you connect to your Polycom QDX 6000 system
may be set to a configuration that is appropriate for video conferencing
applications. Depending on your environment and model of monitor,
however, the video may exhibit one of these problems:
• Picture is too dark or too bright
• Colors appear faded
• Picture has too much of one color — for example, the picture may appear
greenish
• Picture has blocky or softened edge detail
If you notice any of these problems, adjust the monitor's color balance,
sharpness, and brightness until the display seems acceptable. Use the video
diagnostics test as described in the following steps, or purchase a calibration
program DVD tool to help you fine-tune the display settings.
To set the PIP to...
Stay on for the duration of the call.
Be shown when the user operates the
remote control and be turned off when the
user puts the remote control on the table.
Be turned off during the call.
PIP on the remote control to switch to the PIP
Monitors and Cameras
3 - 5