Configuring Monitor Settings - Polycom QDX 6000 System Administrator's Manual

Administrator Guide for Polycom QDX 6000 System

Configuring Monitor Settings

3 - 2
To configure monitors:
1. Go to System > Admin Settings > Monitors.
2. Configure these settings on the Monitors screen:
Setting
Number of Monitors
Output Upon Screen
Saver Activation
(Monitor 1)
Aspect Ratio
(Monitor 1)
PIP(Monitor 1)
Output Upon Screen
Saver Activation
(Monitor 2)
Description
Specifies the number of monitors to use.
Specifies the screen saver output for Monitor 1:
Specifies whether black video or no signal is sent to the
monitor when the system goes to sleep and the screen
saver activates.
Select Black if you want to display screen saver text. This
is the recommended setting to prevent burn-in for TV
monitors.
Select No Signal if you want the display to react as if it is
not connected when the system goes to sleep. This is the
recommended setting for VGA monitors and projectors.
Specifies the monitor's aspect ratio:
• 4:3 — Select if you are using a regular TV monitor.
• 16:9 — Select if you are using a wide-screen monitor.
Specifies PIP (Picture-in-Picture) behavior:
• On — The PIP window stays on for the duration of the
call.
• Auto — Shows the PIP window when the user operates
the remote control (the PIP window is closed when the
user presses the hook at the bottom of remote control,
and it is opened when the hook is released).
• Off — The PIP window is not displayed during the call.
Note: PIP settings are also available in the User Settings
screen.
Specifies the screen saver output for Monitor 2.
Specifies whether black video or no signal is sent to the
monitor when the system goes to sleep and the screen
saver activates.
Select Black if you want to display black video. This is the
recommended setting to prevent burn-in for TV monitors.
Select No Signal if you want the display to react as if it is
not connected when the system goes to sleep. This is the
recommended setting for VGA monitors and projectors.