Enabling A Security Profile - Polycom QDX 6000 System Administrator's Manual

Administrator Guide for Polycom QDX 6000 System

Enabling a Security Profile

8 - 6
Points to note about Security Mode:
• SNMP access is not available in Security Mode.
• Global Management System, ReadiManager SE200, and Polycom CMA
systems cannot monitor Polycom QDX 6000 systems in Security Mode.
• If Security Mode is enabled, you must enter the room password to reset the
system (System > Diagnostics > Reset System). If you forget the room
password while the system is in Security Mode, refer to
Button on page 12-2.
• The web interface allows only HTTPS connections using TLS when Security
Mode is enabled. Make sure that your web browser has TLS capabilities
enabled.
To access a Polycom QDX 6000 system in Security Mode using the Polycom QDX
6000 web interface:
1. Enter the IP address of the system using secure HTTPS access, for
example, https://10.11.12.13.
2. Click Yes in the security dialogs that appear. This access uses port 443.
3. To access Admin Settings using the Polycom QDX 6000 web interface
when a remote access password is set, enter the administrator account (
"admin" is default).
You can configure a Security Profile in the setup wizard only. If set to DoD
DSN, the Security Profile sets and controls particular security settings in order
to meet DoD DSN requirements. For a list of pre-defined values and additional
restrictions applied by the Security Profile, refer to the U.S. DoD DSN
Deployment Guide available on the Polycom web site.
To enable a Security Profile:
 In the setup wizard, enable Security Mode and set Security Profile to
DoD DSN.
To view the Security Profile setting:
 Go to System > Admin Settings > General Settings > Security > Security
Settings.
If you do not see the Security Profile setting, it is set to None and no
settings are controlled by the Security Profile.
Using the Restore