Powering On And Off; Powering On The Polycom Qdx 6000 Systems - Polycom QDX 6000 System Administrator's Manual

Powering On and Off

Powering On the Polycom QDX 6000 Systems

Connect power and power on the system after you have connected all of the
equipment that you will use with it. Make sure that the system is powered off
before you connect devices to it.
To power on the Polycom QDX 6000 systems:
 Press the power switch on the back of the system.
The Polycom splash screen is displayed within about 1 minute.
To power off the Polycom QDX 6000 systems:
 Press the power switch on the back of the system.
The indicator light on the front of the Polycom QDX 6000 system provides this
information:
Indicator Light
Off
Steady red light
Blinking red light
Steady green light
Blinking red light against steady green
light
Steady blue light
Blinking red light against steady blue light
Blinking blue light (on 1 sec, off 1sec)
Introducing the Polycom QDX 6000 Systems
System Status
System is powered off.
System is initializing.
System is updating software.
System is in a call.
System received an IR signal while in
a call.
System is awake, not in a call.
System received an IR signal while
awake and not in a call.
System is asleep.
1 - 3