Connecting Cameras; Connecting Cameras To Polycom Qdx 6000 Systems - Polycom QDX 6000 System Administrator's Manual

Connecting Cameras

Connecting Cameras to Polycom QDX 6000 Systems

• Consider decreasing the monitor's sharpness, brightness, and contrast
settings if they are set to their maximum values.
Polycom QDX 6000 systems provide inputs for PTZ cameras. You can use the
RS-232 serial port on the system to control supported non-Polycom cameras or
cameras not connected to a main camera input.
Refer to your system's setup sheet for connection details. If you connect a
supported PTZ camera, the system detects the camera type and sets the
appropriate configuration. Make sure that the system is powered off before
you connect devices to it.
The following table shows how you can connect video sources to a Polycom
QDX 6000 system.
Video Input
Number Connector
1 (main S-Video
camera)
2 (auxiliary RCA
camera)
3 (document S-Video
camera)
4 (VCR) RCA
5 (VGA) VGA
Acceptable Input
S-Video
Composite
S-Video
Composite
VGA
Monitors and Cameras
Power Control
Provided Camera PTZ,
IR Input
None None
None None
None None
None None
3 - 7