Icom IC-2725E Instruction Manual page 29

z Push [BAND] to select main band.
BANK
x Push [FUNC], the push [
lect frequency band selecting condition.
• The frequency band initial is displayed.
c Push [Y]/[Z] to select the desired frequency
[Y]/[Z]
band.
v Push [
A(MW)] to exit the condition, and re-
CLR
turn to frequency indication.
D VFO and memory modes
The transceiver has 2 basic operating modes: VFO mode and
1(MONI)] to se-
memory mode. Select VFO mode first to set an operating fre-
BANK
quency.
➥ Push the desired band's [V/MHz•SCAN] to select VFO
➥ Push [M/CALL•MW] to select memory mode.
SETTING A FREQUENCY
Push [V/MHz•SCAN]
to select VFO mode
Push [M/CALL•MW]
to select memory mode
MAIN
T X
M
VFO mode is selected
mode.
• When VFO mode is already selected, the digit below 10 MHz
(the digit below 1 MHz or 100 kHz disappear depending on ver-
sions) disappear. In this case, push [V/MHz•SCAN] again (or
twice or 3 times depending on version).
• "!" indicator appears when memory mode is selected.
➥ Push [VFO/LOCK] to select VFO mode.
➥ Push [MR/CALL] to select memory mode.
VFO/LOCK
• The microphone controls the main band only. Push
[BAND] to toggle the main band, then push
[VFO/LOCK] or [MR/CALL], if necessary.
MAIN
T X
M
"!" indicator appears when
memory mode is selected
2
2
12