I Scan Resume Condition; Scan Operation - Icom IC-2725E Instruction Manual

I Scan resume condition

The scan resume condition can be selected as timer or pause
scan. The selected resume condition is also used for priority
watch. (p. 46)
MAIN
T X
M
q Push [MAIN•BAND] to select the desired band (left or right)
as the main band.
w Push [SET•
] to enter set mode.
e Push [SET•
] or [LOW•PRIO] several times until "SCt"
or "SCP" appears as shown above.
• When "d" is displayed in place of the 100 MHz digit, cancel the
DTMF memory encoder in advance. (p. 49)
r Rotate the main band's [DIAL] to set the desired timer:
• "SCt-15" : Scan pauses 15 sec. while receiving a signal.
• "SCt-10" : Scan pauses 10 sec. while receiving a signal.
• "SCt-5" : Scan pauses 5 sec. while receiving a signal.
• "SCP-2" : Scan pauses until the signal disappears and then
resumes 2 sec. later.
t Push [TONE•DTMF] to exit set mode.
SET MODE
USING
The display shows that the
scan will resume 15 sec. after
it stops.

SCAN OPERATION

z Push [BAND] to select the desired band (left or
SET
right) as the main band.
B
x Push [
B(D-OFF)] to enter set mode.
SET
c Push [
B(D-OFF)] or [
SET
times until "SCt" or "SCP" appears as shown at
left.
v Push [Y] or [Z] to select the scan resume condi-
tion.
• See item r at left for scan resume condition details.
b Push [
A(MW)] to exit set mode.
CLR
7
C(T-OFF)] several
ENT
7
44