I Packet Operation; D Cloning Using A Personal Computer - Icom IC-2725E Instruction Manual

11
OTHER FUNCTIONS

D Cloning using a personal computer

Data can be cloned to and from a personal computer (Mi-
crosoft ® Windows ® 98/2000/Me/XP) using the optional CS-
2720
CLONING SOFTWARE
OPC-478U (USB type) or OPC-478 (RS-232C type). Consult
the CS-2720
CLONING SOFTWARE
D Cloning error
NOTE: DO NOT push any key on the sub-transceiver dur-
ing cloning. This will cause a cloning error.
When the display as below appears, a cloning error has oc-
curred.
MAIN
T X
In such a case, both transceivers automatically return to the
clone standby condition and cloning must be repeated.
Microsoft and Windows are registered trademarks of Microsoft Corporation in
the U.S.A. and other countries.
67
and the optional cloning cable
HELP file for details.
MAIN
T X
M M

I Packet operation

D Data speed
For packet operation, the transceiver can be set to one of two
data speeds: 1200 bps (default) or 9600 bps.
q While pushing [SET•
] turn power ON to enter initial set
mode.
w Push [SET•
] or [LOW•PRIO] to select the 'bPS' item.
e Rotate the left band [DIAL] to select the desired data
speed.
MAIN
T X
M
r Push [PWR] to exit initial set mode.
For 1200 bps operation—
• Disconnect the microphone plug from the microphone
connector during data transmission, otherwise the data
signal and voice signal are simultaneously transmitted.
For 9600 bps operation—
• When the transceiver is set for 9600 bps data transmis-
sion in set mode, the microphone signal is automatically
cut. Therefore, it is not necessary to disconnect the mi-
crophone plug from the connector in this case.
• When pushing [PTT] during data transmission, data trans-
mission is interrupted and voice signals have priority.
MAIN
T X
M