I Memory Clearing - Icom IC-2725E Instruction Manual

5
MEMORY OPERATION

I Memory clearing

Contents of programmed memories can be cleared (blanked),
if desired.
q Push [V/MHz•SCAN] to select VFO mode in the desired
band (left or right).
w Push the same band's [M/CALL•MW] for 1 sec.
• "!" indicator and the memory channel number blink.
e Rotate the same band's [DIAL] to select the memory chan-
nel to be cleared.
• Memory channels not yet programmed are blank.
[EXAMPLE]: Clearing memory channel 20.
V/MHz
Push to select VFO.
SCAN
MAIN
T X
Push M/CALL momentarily, then push
MW
"
Beep
"
Beep
"
33
M/CALL
Push for 1 sec.
MW
M
M/CALL again for 1 sec.
MW
"
MAIN
T X
Beep
M
"
r Push the same band's [M/CALL•MW] momentarily, then
push the [M/CALL•MW] again for 1 sec.
This operation must be performed within 1.5 sec.
• 3 beeps sound, then the frequency is cleared.
• "!" indicator and the channel number blink continuously.
• When clearing the call channel, the current VFO conditions are
re-programmed into the call channel automatically.
t Push the same band's [MAIN•BAND] or [V/MHz•SCAN], to
return to VFO mode.
NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
Rotate
MAIN
T X
M
Push any switch, except
MAIN
T X
for selecting memory channel.
MAIN
T X
M
M/CALL .
MW
M