I Programming A Call Channel; Call Channel Operation - Icom IC-2725E Instruction Manual

I Programming a call channel

Operating frequency, duplex information, subaudible tone in-
formation (tone encoder or tone squelch ON/OFF and its fre-
quency) can be programmed into the call channel.
q Set the desired frequency in VFO mode.
➥ Push the desired band's [V/MHz•SCAN] to select VFO
mode.
➥ Set the frequency using the same band's [DIAL].
➥ Set other data as desired.
w Push the same band's [M/CALL•MW] for 1 sec.
e Rotate the [DIAL] to select the desired call channel.
• "!" indicator and "C1" or "C2" blink.
[EXAMPLE]: Programming 145.120 MHz into the call channel 2 via the microphone.
Push to select VFO mode.
MAIN
T X
M
Push until large "C" appears.
MAIN
T X
Set the frequency.
MAIN
T X
Push , then push
MAIN
T X
M

CALL CHANNEL OPERATION

r Push the [M/CALL•MW] for 1 sec. to program.
• 3 beeps sound and the unit returns to VFO mode automatically.
z Set the desired frequency in VFO mode.
MR/CALL ➥ Push [VFO/LOCK] to select VFO mode.
➥ Set the frequency.
➥ Set other data as desired.
MW
x Push [FUNC], then [
c Select the call channel via [Y] or [Z] .
v Push [FUNC] then [
[Y]/[Z]
program.
• 3 beeps sound and the unit returns to VFO mode
automatically.
Push
M
➠
for 1 sec.
"
"
Beep
"
Beep
"
Beep
M
"
A(MW)] momentarily.
CLR
A(MW)] for 1 sec. to
CLR
, then .
MAIN
T X
M
MAIN
T X
M
6
6
38