Add; Where Issued; Security Restrictions; Rdf State Requirement - HP NonStop RDF J-series RVUs Management Manual

ADD

The ADD command applies configuration parameter values for the specified process or other
object from the RDF configuration memory table to the RDF configuration file.
ADD {RDF
{MONITOR
{EXTRACTOR
{RECEIVER
{IMAGETRAIL $volume
{PURGER
{RDFNET
{NETWORK
{[VOLUME] $volume
{TRIGGER trigger-type }
RDF
applies RDF global configuration parameters.
MONITOR
applies configuration parameters for the monitor.
EXTRACTOR
applies configuration parameters for an extractor.
RECEIVER
applies configuration parameters for a receiver.
IMAGETRAIL $volume
adds a secondary image trail to the configuration, implicitly identifying that trail by the name
of the volume on the backup system to be used for its storage. You can add secondary image
trails only after RDF has been initialized and before it has been started for the first time. You
must also previously have added the receiver process.
PURGER
applies configuration parameters for the purger.
RDFNET
applies configuration parameters for the RDFNET process.
NETWORK
applies configuration parameters for an RDF network.
[VOLUME] $volume
applies configuration parameters for an updater process, implicitly identifying the updater
process by the name of the volume on the primary system for which this process is responsible.
The updater volume must be audited by TMF.
TRIGGER trigger-type
applies configuration parameters for a trigger entity. trigger-type is either REVERSE or
TAKEOVER.

Where Issued

Primary system only.

Security Restrictions

You can issue the ADD command if you are a member of the super-user group.

RDF State Requirement

Except for the ADD VOLUME and ADD TRIGGER commands, you can issue any ADD command
only after initializing RDF but before entering the first START RDF command. After RDF is
initialized, you can issue an ADD VOLUME or ADD TRIGGER command anytime RDF is stopped.
}
}
}
}
}
}
}
}
}
RDFCOM Commands 193