HP NonStop RDF J-series RVUs Management Manual page 446

Effect Some updaters might have shut down, but others never received the stop message
and are still running. The receiver and monitor cannot now identify these updaters, and you
cannot stop them with another STOP UPDATE command or a STOP RDF command.
Recovery
example, with a TACL STOP $UPD1 command). Examine the EMS event log for the error
message 841; this message contains the Guardian error number that the monitor received when
attempting to stop the updater.
Storing missing audit in the imagetrail.
Cause
The COPYAUDIT command has located the missing audit for the image trail identified
in the previous message and is ready to move that audit from the remote system to the local
system.
Effect
The COPYAUDIT command moves the audit to the local system.
Recovery
SUFFIX must be a single alphanumeric character
Cause
You specified an incorrect value for the SUFFIX option of the INITIALIZE RDF
command.
Effect The INITIALIZE RDF command is aborted.
Recovery
character.
Swap File Error: error#
error#
is the file-system error number that identifies the specific error.
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The command fails.
Recovery
details about understanding and correcting process errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the command that encountered
the error. Otherwise, see your system manager.
Synch point for synchdbtime has been found
synchdbtime
is a SYNCHDBTIME timestamp specified previously by an operator in an RDFCOM
INITIALIZE RDF command.
Cause
In conjunction with a complete database synchronization, a record whose timestamp
is less than synchdbtime has been located successfully.
Effect The RDFCOM INITIALIZE RDF command continues.
Recovery
Synch timestamp is synchdbtime
synchdbtime
is a SYNCHDBTIME timestamp specified previously by an operator in an RDFCOM
INITIALIZE RDF command.
Cause In conjunction with a complete database synchronization, you are attempting to
initialize RDF to a timestamp that is earlier than the current time. A record whose timestamp
is less than synchdbtime has been found, and synchdbtime has been stored in the RDF
configuration record.
Effect The RDFCOM INITIALIZE RDF command continues.
Recovery
TAKEOVER in progress
446 Messages
All remaining updaters must be manually stopped from the TACL interface (for
This is an informational message; no recovery is required.
Reenter the command, specifying a single alphanumeric character for the suffix
See the Operator Messages Manual for a description of the error code. For additional
This is an informational message; no recovery is required.
This is an informational message; no recovery is required.