HP NonStop RDF J-series RVUs Management Manual page 437

Cause The RDF configuration file is invalid: both primary and backup node names are
identical.
Effect
The validation fails.
Recovery
Alter the RDF configuration to reflect different names for these two nodes.
Process Name Error: error#
error#
is the error number that identifies the specific error.
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The START RDF or TAKEOVER operation is aborted.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting process errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the command that encountered
the error. Otherwise, contact your service provider.
Program and Library File are the Same
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The START RDF or TAKEOVER operation is aborted.
Recovery
Change the library filename.
Program File Error: error# on progfile
error#
is the error number that identifies the specific error.
progfile
is the name of the program file on which the error was encountered.
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The START RDF or TAKEOVER operation is aborted.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting process errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the command that encountered
the error. Otherwise, see your system manager.
RDF already in TAKEOVER processing
Cause
The operator issued a TAKEOVER command at the backup node while RDF was
performing a TAKEOVER operation.
Effect The last TAKEOVER command is ignored.
Recovery This is an informational message; no recovery is required.
RDF configuration file is not open, use OPEN command
Cause The configuration file must be open before any RDFCOM commands other than
OPEN or OBEY can be executed.
Effect
The attempted operation is aborted.
Recovery
Open the configuration file with the OPEN command.
RDF has not been initialized.
Cause You issued an INITIALIZE RDF command, but entered NO or N in response to the
subsequent confirmation prompt for continuing the initialization process.
Effect
RDF is not initialized.
Recovery
This is an informational message; no recovery is required.
RDF LOGFILE filename NOT a legal filename on system \node
RDFCOM Messages 437