HP NonStop RDF J-series RVUs Management Manual page 390

Cause The operator issued a TAKEOVER command.
Effect RDF starts a TAKEOVER operation.
Recovery
812
Error error communicating with procname
error
is the file-system error number that identifies the specific error.
procname
is the name of the process with which the updater cannot communicate.
Cause
The updater encountered a file-system error while attempting to communicate with
the receiver or purger. The file-system error number and the name of the receiver or purger
are included in the message.
Effect
This is a catastrophic error; the updater abends, and RDF will abort.
Recovery
the condition, and restart RDF.
813
Concurrent file opens exceed capacity
Cause This message is reported by updater processes when the number of concurrent file
opens exceeds the capacity of the table in which the updater maintains information about file
opens.
Effect The updater will close idle files (if any) and continue. If there are no idle files, then
the updater will close all files and establish a restart point from which processing can continue.
In the latter case, there will be a performance degradation.
Recovery
administrator should consider moving some of the files protected by TMF on the primary
node volume to another volume, and adding another updater to back up the new volume. If
you do that, you must synchronize the affected volumes on the primary and backup nodes.
814
Backup process takeover in processor cpu
cpu
is the number of the processor in which the backup process is now running.
Cause The primary process has stopped for some reason, perhaps a cpu failure.
Effect The backup process of the process pair has taken over.
Recovery
process stopped and take corrective action if necessary.
815
Primary process takeover in processor cpu
cpu
is the number of the processor in which the primary process is now running.
Cause
A new primary process has been created by the backup process, and the backup
process has switched control to this primary process.
Effect The primary process of the process pair has taken over.
Recovery
816
Image trail file SETMODE error error on filename
390 Messages
This is an informational message; no recovery is required.
Determine the cause of the error. If the receiver or purger did not abend, correct
This is an informational message. If the condition persists, however, your database
This is an informational message, although you should determine why the primary
This is an informational message; no recovery is required.