HP NonStop RDF J-series RVUs Management Manual page 376

For j-series and h-series rvus
Table of Contents

Advertisement

filename
is the name of the file that the updater tried to create.
Cause
An updater was unable to create a file on its UPDATEVOLUME disk. The message
includes both the file-system error number and the name of the file the updater attempted to
create.
Effect
See
Recovery
740
Create for unprotected RDF volume failed volume. Error error
volume
is the name of the volume that could not be found among those protected by RDF.
error
is the file-system error number that identifies the specific error.
Cause
This warning message is issued when a create operation for the primary partition of
a partitioned file must map one or more of the file's secondary partitions to a volume that does
not match any of the volumes protected by RDF on the primary node. This message is also
issued when the creation of a file with alternate keys is attempted and the corresponding
alternate key file does not match any of the volumes protected by RDF on the primary node.
Effect
The create operation fails and is skipped.
Recovery
file is on a volume protected by RDF, then all partitions and alternate key files must be on
volumes protected by RDF.
Either the file must be redefined on the primary node, or the other volume must be made
protected by RDF. In the latter case, the backup file must then be resynchronized with the
primary file.
741
RDF extractor message out of order
Cause
The receiver has received a message from the extractor that is out of order. When this
event occurs, the extractor automatically reestablishes synchronization with the receiver. If
the extractor has several outstanding requests to the receiver and the first is found to be out
of order, the receiver rejects each subsequent request with this same error. When the extractor
reestablishes synchronization, normal processing resumes.
Effect
The receiver directs the extractor to reestablish synchronization.
Recovery
742
RDF extractor internal audit read error. File filename RBA rba
filename
is the name of the audit trail file that contained the error.
rba
is the relative byte address where the error occurred in the audit trail file.
Cause
The extractor encountered an error in audit processing.
Effect
The extractor abends, thereby stopping the other RDF processes.
Recovery
You must reinitialize RDF.
743
Catastrophic error encountered
376
Messages
Table 5-3 (page 123)
to determine the effect of this error.
See
Table 5-3 (page 123)
For partitioned files and files with alternate keys, if any partition or alternate key
This is an informational message; no recovery is required.
Save the SAVEABEND file, the audit trail file, and contact your service provider.
to determine the appropriate recovery actions.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nonstop rdf h-series rvusNonstop rdf

Table of Contents