HP NonStop RDF J-series RVUs Management Manual page 452

Recovery
to verify the configuration, and reissue your request for the RDFCOM operation you originally
wanted to perform.
TMF NAT table is full.
Cause
There is a problem with TMF.
Effect
The configuration validation fails.
Recovery
TMF Shutdown at timestamp has been found. RDF starts with MAT file
filename at RBA relative-byte-address
timestamp
is the shutdown timestamp sought.
filename
is the name of the MAT file that contained the record with the matching timestamp.
relative-byte-address
is the relative byte address where the record with the matching timestamp was found in
the MAT file.
Cause
RDFCOM has found the TMF shutdown timestamp identical to the timestamp specified
in the INITIALIZE RDF timestamp command.
Effect
RDF is ready to be initialized at the specified timestamp.
Recovery
TMF STOP in progress.
Cause A TMF stop operation is in progress.
Effect TMF stops, and RDF automatically stops thereafter.
Recovery
To issue this command, the RTD time of the extractor must be 0:00. Have
you confirmed that the RTD is 0:00?
Cause
You are attempting to execute an RDFCOM STOP SYNCH command. To ensure that
the extractor does not miss any audit record, the extractor RTD must be 0:00 before executing
this command.
Effect
You are prompted for a "yes" or "no" response.
Recovery
Too many volumes are configured (number > max)
max
is 64 for RDF, and 255 for the RDF/MP, MPX, IMP, or IMPX
Cause The maximum number of volumes that can be protected on a node (64 for RDF, 255
for RDF/MP, MPX, IMP, or IMPX) has been exceeded.
Effect
The configuration validation fails.
Recovery
Too many volumes are specified in this ALTER command
Cause
You specified too many volumes in the command parameter list of an ALTER
command.
Effect The ALTER command aborts.
Recovery
Triple Contingency CopyAudit command aborted.
452 Messages
Check the contents of the RDF configuration file, issue a VALIDATE RDF command
Check the status of TMF. When TMF is operational, reenter the command.
This is an informational message; no recovery is required.
This is an informational message; no recovery is required.
Enter YES (or Y) to execute the command or NO (or N) to cancel it.
Delete some of the volumes.
Eliminate some of the volumes from the command parameter list.