Show Rdfnet Command; Show Network Command; Show Trigger Command; Start Rdf - HP NonStop RDF J-series RVUs Management Manual

• The updater is to use the secondary image trail $SECIT1 (which was previously added to
the RDF configuration by way of an ADD IMAGETRAIL command).
• You have configured this updater only to replicate file in the subvolume MYFILESET.*, but
you do not want to replicate MYFILESET.LOG.
To display the values specified by those SET VOLUME commands, enter:
]SHOW VOLUME
This output results:
VOLUME ATINDEX 1
VOLUME CPUS 2:1
VOLUME PRIORITY 160
VOLUME UPDATEVOLUME $DATA7
VOLUME IMAGEVOLUME $SECIT1
VOLUME PROCESS $UP07
VOLUME INCLUDE MYFILESET.*
VOLUME EXCLUDE MYFILESET.LOG

SHOW RDFNET Command

Suppose that a series of SET RDFNET commands specifies the RDFNET process named $MNET
is to run in CPUs 0 and 1 at priority 180.
To display the values specified by those SET RDFNET commands, enter:
]INFO RDFNET
RDF displays:
RDFNET PROCESS $MNET
RDFNET CPUS 0:1
RDFNET PRIORITY 180

SHOW NETWORK Command

Suppose that a series of SET NETWORK commands specifies \RDF04 as the network master's
primary system, \RDF06 as the network master's backup system, RDF04 as the network master's
remote control subvolume, and $DATA07 as the network master's PNETTXVOLUME volume.
To display the values specified by those SET NETWORK commands, enter:
]SHOW NETWORK
RDF displays:
NETWORK PRIMARYSYSTEM \RDF04
NETWORK BACKUPSYSTEM \RDF06
NETWORK RCSV RDF04
NETWORK PNETTXVOLUME $DATA07

SHOW TRIGGER Command

If you have entered a series of SET TRIGGER commands and you want to review them before
issuing the ADD TRIGGER command, type:
]SHOW TRIGGER
RDF displays a list like this:
TRIGGER PROGRAM $SYSTEM.RDF.RDFCOM
TRIGGER INFILE $DATA01.RDF.RDFCONF
TRIGGER OUTFILE $DATA01.RDF.OUTFILE
TRIGGER CPUS 0:1
TRIGGER PRIORITY 150
TRIGGER NOWAIT

START RDF

The START RDF command starts RDF.
242 Entering RDFCOM Commands