Set Network; Set Purger; Set Rdf - HP NonStop RDF J-series RVUs Management Manual

{CPUS primary-CPU : backup-CPU }
{PRIORITY priority
{PROCESS

SET NETWORK

The SET NETWORK command sets RDF network configuration parameters within the RDF
configuration memory table. The supplied values are not applied to the RDF configuration file,
however, until you issue an ADD NETWORK command.
Where Issued: Primary system only.
Security: Super-user group member.
SET NETWORK network-option
where network-option is:
{PRIMARYSYSTEM primary-system
{BACKUPSYSTEM backup-system
{REMOTECONTROLSUBVOLUME subvolume }
{PNETTXVOLUME $volume

SET PURGER

The SET PURGER command sets the designated configuration parameters for the purger process
to the supplied values within the RDF configuration memory table. The supplied values are not
applied to the RDF configuration file, however, until you issue an ADD command.
Where Issued: Primary system only.
Security: Super-user group member.
SET PURGER purger-option
where purger-option is:
{CPUS primary-CPU : backup-CPU}
{PRIORITY priority
{PROCESS
{PURGETIME mins
{RETAINCOUNT num

SET RDF

The SET RDF command sets the designated RDF global configuration parameters to the supplied
values within the RDF configuration memory table. The supplied values are not applied to the
RDF configuration file, however, until you issue an ADD command.
Where Issued: Primary system only.
Security: Super-user group member.
SET RDF global-option
where global-option is:
{LOGFILE $ems-collector-name
{UPDATERDELAY delay-time
{UPDATERTXTIME tx-time
{UPDATERRTDWARNING rtd-time
{UPDATEROPEN {PROTECTED | SHARED|PROTECTED OPEN} }
{SOFTWARELOC $volume.subvolume
{NETWORK {ON | OFF}
{NETWORKMASTER {ON | OFF}
{UPDATEREXCEPTION {ON | OFF}
{LOCKSTEPVOL $volume
{REPLICATEPURGE {ON | OFF}
{REMOTE MIRROR {ON | OFF}
{REMOTE STANDBY {node-name}
{OWNER {owner-id}
process-name
process-name
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
}
RDFCOM Commands Quick Reference 353