]SET EXTRACTOR RTDWARNING 180
]ADD EXTRACTOR
To configure a master extractor in an RDF/ZLT environment, where there are two active volumes
($TMFMAT1 and $TMFMAT2), and one overflow volume ($MATOFLO), issue the following
commands:
]SET EXTRACTOR PROCESS $EXTR
]SET EXTRACTOR CPUS 3:4
]SET EXTRACTOR RTDWARNING 165
]SET EXTRACTOR VOLUME $TMFMAT1
]SET EXTRACTOR VOLUME $TMFMAT2
]SET EXTRACTOR VOLUME $TMFOFLO
]ADD EXTRACTOR
SET IMAGETRAIL
The SET IMAGETRAIL command associates an image trail with a specific audit trail on the
primary system. The supplied value is not applied to the RDF configuration file, however, until
you issue an ADD IMAGETRAIL command.
SET IMAGETRAIL ATINDEX audittrail-index-number
ATINDEX audittrail-index-number
is an integer value identifying a configured TMF audit trail on the primary system. 0 specifies
the MAT. 1 through 15 specify auxiliary audit trails AUX01 through AUX15.
If 0, the image trail specified in the subsequent ADD IMAGETRAIL command is managed
by the master receiver; if 1 through 15, it is managed by the auxiliary receiver with that same
ATINDEX value. The default value is 0.
For information about protecting auxiliary audit trails, see
Usage Guidelines
For ATINDEX values greater than 0, the specified value must match the audit trail number of a
configured auxiliary audit trail. If you specify SET IMAGETRAIL ATINDEX 2, for example, there
must be a configured auxiliary audit trail AUX02.
Furthermore, RDF objects with a particular ATINDEX value greater than 0 must together constitute
a complete set:
•
If there is an extractor with an ATINDEX value of 1, there must also be a receiver with an
ATINDEX value of 1.
•
If there is a receiver with an ATINDEX value of 1, there must also be a secondary image trail
with an ATINDEX of 1.
•
An updater with an ATINDEX value of 1 must be protecting a primary system data volume
configured to auxiliary audit trail AUX01, and its secondary image trail must also have an
ATINDEX value of 1.
SET MONITOR
The SET MONITOR command sets monitor process configuration parameters within the RDF
configuration memory table. The supplied values are not applied to the RDF configuration file,
however, until you issue an ADD MONITOR command.
SET MONITOR monitor-option
where monitor-option is:
{CPUS primary-CPU : backup-CPU }
{PRIORITY priority
{PROCESS
224
Entering RDFCOM Commands
process-name
Chapter 13 (page
}
}
291).