HP NonStop RDF J-series RVUs Management Manual page 460

You cannot add more than 48 network records
Cause
The current limit for the number of RDF subsystems in your RDF network is 48 and
you have attempted to add 49.
Effect The configuration command fails.
Recovery
You cannot alter MAPFILE on the backup system if the primary system is
available
Cause
During execution of an ALTER VOLUME command on the backup system, RDFCOM
determined that the primary system is accessible.
Effect The command fails.
Recovery
You cannot alter MAPLOG on the backup system if the primary system is
available
Cause
During execution of an ALTER VOLUME command on the backup system, RDFCOM
determined that the primary system is accessible.
Effect
The command fails.
Recovery
You cannot START RDF after an RDF Takeover operation.
Cause You tried to start RDF after an RDF takeover operation has been performed.
Effect The START RDF command fails.
Recovery
takeover operation completed successfully.
You cannot start updaters before the extractor has completed Phase 2
of its online database synchronization operation.
Cause You tried to start updaters by either a START RDF or START UPDATE command
before the extractor completed Phase 2 of its database synchronization operation.
Effect
The START RDF or START UPDATE command fails.
Recovery
updaters. You can, however, issue a START RDF, UPDATE OFF command.
You have not added the master EXTRACTOR yet
Cause You tried to add an auxiliary extractor before adding the master extractor.
Effect The ADD command fails.
Recovery
You have not added the master RECEIVER yet
Cause You tried to add an auxiliary receiver before adding the master receiver.
Effect The ADD command fails.
Recovery
You must specify the year with four digits
Cause
You specified the year in a timestamp with less than four digits.
Effect
The command involving the timestamp fails.
Recovery
460 Messages
Do not add any more network records.
Reenter the command on the primary system.
Reenter the command on the primary system.
You must initialize RDF on the primary system. You should also ensure that the
You must wait until the extractor has logged message 782 before starting the
You must add the master extractor first.
You must add the master receiver first.
Reissue the command, specifying a four-digit year in the timestamp.