Initial Startup Dialog - Qlogic SANbox 5602 User Manual

0
To start SANsurfer Switch Manager from SANsurfer Management Suite, do
the following.
1.
2.
3.
The application opens with the Initial Start dialog shown in
not to see this dialog, check the Don't show this dialog again box. This has the
same effect as disabling the Display Initial Startup Dialog preference. Refer to
"Setting SANsurfer Switch Manager Preferences" on page 2-15
about setting preferences.
Click the Open Existing Fabric radio button to open the Add a New Fabric
dialog, which prompts you for a fabric name, IP address, account name, and
password. Refer to
59097-00 A
Start the SANsurfer Management Suite application using one of the
following methods:
For Windows, double-click the SANsurfer shortcut, or select
SANsurfer from Start menu, depending on how you installed the
SANsurfer application. From a command line, enter the following
command:
<install_directory>\SANsurfer.exe
For Linux or Solaris enter the SANsurfer command:
<install_directory>./SANsurfer
From the SANsurfer Management Suite home page, click the
SANsurfer Switch Manager button.
In the Initial Start dialog, click the Open Configuration Wizard button.
When you power up the switch, the Configuration Wizard will
recognize the switch and lead you through the configuration process.
Figure 2-1. Initial Startup Dialog
"Adding a Fabric" on page
2 – Using SANsurfer Switch Manager
Starting SANsurfer Switch Manager
Figure 2-1. If you prefer
for information
3-5.
2-9