Qlogic SANbox 5602 User Manual page 218

A – Command Line Interface
Show Command
LogLevel
MaxPorts
NumberOfResets
ReasonForLastReset
ActiveImageVersion - build date
PendingImageVersion - build date
ActiveConfiguration
AdminState
AdminModeActive
BeaconOnStatus
OperationalState
PrincipalSwitchRole
BoardTemp (1) - Degrees Celsius
SwitchDiagnosticsStatus
SwitchTemperatureStatus
topology
Displays all connected devices.
users
Displays a list of logged-in users. This is equivalent to the User List command.
version
Displays an introductory set of information about operational attributes of the
switch. This keyword is equivalent to the About keyword.
A-68
Table A-16. Switch Operational Parameters (Continued)
Parameter Description
Event severity level used to record
events in the event log
Number of ports available on the switch
Number of times the switch has been
reset over its service life
Action that caused the last reset
Active firmware image version and build
date.
Firmware image version and build date
that is pending. This image will become
active at the next reset or power cycle.
Name of the switch configuration that is
in use.
Switch administrative state
Admin session status
Beacon status as set by the Set Beacon
command.
Switch operational state
Principal switch status. True indicates
that this switch is the principal switch.
Internal switch temperature at circuit
board sensor 1
Results of the power-on self test
Switch temperature status: normal,
warning, failure
0
59097-00 A