Qlogic SANbox 5602 User Manual page 209

0
Eth0NetworkMask
Eth0GatewayAddress
AdminTimeout
InactivityTimeout
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostAddress
NTPClientEnabled
NTPServerAddress
EmbeddedGUIEnabled
59097-00 A
Table A-14. System Configuration Settings (Continued)
Entry Description
Ethernet subnet mask address.
Ethernet IP address gateway.
Amount of time in minutes the switch waits before
terminating an idle Admin session. Zero (0)
disables the time out threshold. The default is 30,
the maximum is 1440.
Amount of time in minutes the switch waits before
terminating an idle Telnet command line interface
session. Zero (0) disables the time out threshold.
The default is 0, the maximum is 1440.
Enables (True) or disables (False) the saving of log
information on the switch. The default is True.
Enables (True) or disables (False) the recording of
the switch event log on a remote host that supports
the syslog protocol. The default is False.
The IP address of the host that will receive the
switch event log information if remote logging is
enabled. The default is 10.0.0.254.
Enables (True) or disables (False) the Network
Time Protocol (NTP) client on the switch. This
client enables the switch to synchronize its time
with an NTP server. This feature supports NTP
version 4 and is compatible with version 3. An
Ethernet connection to the server is required and
you must first set an initial time and date on the
switch. The synchronized time becomes effective
immediately. The default is False.
The IP address of the NTP server from which the
NTP client acquires the time and date. The default
is 10.0.0.254.
Enables (True) or disables (False) the SANsurfer
Switch Manager Web applet. Changing this
parameter to False while the applet is running will
terminate the applet. The default is True.
A – Command Line Interface
Set Setup Command
A-59