Qlogic SANbox 5602 User Manual page 188

A – Command Line Interface
Set Command
pagebreak [state]
Specifies how much information is displayed on the screen at a time according to
the value given by [state]. This keyword does not require an admin session. [state]
can be one of the following:
on
Limits the display of information to 20 lines at a time. The page break
functions affects the following commands: Alias (List, Members), Show
(Alarm, Log), Zone (List, Members), Zoneset (List, Zones), Zoning (Active,
List).
off
Allows continuous display of information without a break.
port [option]
Sets port state and speed for the specified port. The previous Set Config Port
settings are restored after a switch reset or a reactivation of a switch
configuration. Refer to the
setup [option]
Changes SNMP and system configuration settings. Refer to the
Command" on page
switch [state]
Changes the administrative state for all ports on the switch to the state given by
[state]. The previous Set Config Switch settings are restored after a switch reset
or a reactivation of a switch configuration. [state] can be one of the following:
online
Places all ports online
offline
Places all ports offline.
diagnostics
Prepares all ports for testing.
Examples
The following examples enables and disables the beacon:
SANbox Manager #> set beacon on
Command succeeded.
SANbox Manager $> set beacon off
Command succeeded.
A-38
"Set Port Command" on page
A-57.
0
A-55.
"Set Setup
59097-00 A