Related Manuals for Qlogic SANbox 5202
Summary of Contents for Qlogic SANbox 5202
-
Page 1: Quick Start Guide
Quick Start Guide F I B R E C H A N N E L S W I T C H I N S T A L L A T I O N ® S A N b o x 5 2 0 2 ®... -
Page 3: Installation Instructions
For a surface mount, attach the rubber feet to the locations on the bottom of the switch. ❑ For a rack mount, install the SANbox 5202 rail kit in a standard 19" rack as described in the SANbox 3000/5000 Fibre Channel Switch Rack Mounting Guide that is packaged with the... - Page 4 Step 3. Stack Switches If your switch is licensed for 20 ports, you can connect up to four switches together through the 10-Gbps ports using XPAK switch stacking cables. Stacking provides performance and fail-over while preserving ports for devices. • For a 2-switch stack, use two 3-inch cables. •...
- Page 5 Step 5. Apply Power to the Switch ❑ Attach the AC power cords to the switch INPUT and wall outlet or power strip. Verify that POWER LED the Input Power LED is illuminated. HEARTBEAT ❑ The switch runs its self tests and begins SYSTEM normal operation –...
- Page 6 ©2005 QLogic Corporation. QLogic, SANbox, and SANsurfer Switch Manager are trademarks or registered trademarks of QLogic Corpo- ration. All other trademarks are the property of their respective companies. Information supplied by QLogic is believed to be accurate and reliable. QLogic Corporation assumes no responsibility for any errors in this brochure. QLogic Corporation reserves the right, without notice,...
- Page 8 *50347-01B* QLogic Corporation 26650 Aliso Viejo Parkway Aliso Viejo, CA 92656 949.389.6000 www.qlogic.com 50347-01 B...
Need help?
Do you have a question about the SANbox 5202 and is the answer not in the manual?
Questions and answers