Qlogic SANbox 5602 User Manual page 201

0
The following is an example of the Set Config Zoning command.
SANbox Manager #> admin start
SANbox Manager (admin) #> config edit
SANbox Manager (admin-config) #> set config zoning
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list press 'q'
or 'Q' and the ENTER key to do so.
InteropAutoSave
DefaultVisibility
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
59097-00 A
(True / False) [True]
(All / None) [All ]
A – Command Line Interface
Set Config Command
A-51