Qlogic SANbox 5602 User Manual page 176

A – Command Line Interface
Image Command
12. Wait for the unpack to complete.
13. A message will prompt you to reset the switch to activate the firmware.
Resetting the switch is disruptive. Use the Hotreset command to attempt a
non-disruptive activation.
Examples
The following is an example of the Image Install command:
SANbox Manager (admin) #> image install
Warning: Installing new firmware requires a switch reset.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
User Account
IP Address
Source Filename : 4.2.00.11_mpc
About to install image.
Connected to 10.20.33.130 (10.20.33.130).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
A-26
image unpack command result: Passed
SANbox Manager (admin) $>hotreset
: johndoe
: 10.20.33.130
Do you want to continue? [y/n] y
0
59097-00 A